Manual

147
DXi User Manual
Glossary
Prepping the Chassis
Glossary
Alert / Alarm
An irrigation related "event" reported by the controller which requires operator
notification and/or action.
Central Control Mode
Central Control Mode indicates that two way communications have been established
between the DXi controller and the Central Control PC. This means that
programming data can be downloaded and uploaded, and that the Central Control PC
can control all functions remotely. Central Control Mode can be entered in two ways:
1. If a controller has been setup as a submaster and a valid address has been entered.
2. If the controller is physically connected as a satellite and has established two-way
communications with its submaster.
Condemned Station
A station that shut down due to operational defects or exceeded limits. The
condemned station will not operate again until the defects are corrected and warnings
are cleared.
Continuous Cycle
A watering program that will run continuously within a user defined water window.
After the first cycle, a specified soak time is enforced before the program starts again.
Controller
A microprocessor based solid state programmable apparatus that automatically
controls and manages irrigation valves, pumps, flow sensors and other peripheral