Manual

66
DXi User Manual
Chapter 10: Manual Operation
Station
It is possible to manually activate any station within the DXi system.
Master Valves and/or Pumps can be activated independently of stations by selecting
station '000' then enabling the desired Master Valves and/or Pumps to active.
The DXi monitors current and--if a flow meter is installed--flow.
To Activate Manual Station Operation:
1) to enter Station# field.
2) to select desired station. Set it.
3) and to enter, adjust, and set Run Time.
4) Navigate to the Activate field. to begin the manual station.
Irrigation will begin immediately.
As stations are activated, the master valve (MV) and/or pump (P) associated with that
station will be highlighted, indicating they will activate along with that station. It is possible
to manually enable and disable the master valve/s and pump/s, although Toro does NOT
recommend that.
To Deactivate Manual Station Operation:
1) to Deactivate field.
2) to deactivate.
Station# 001
Run Time 010
Activate Deactivate
Status: Off
Flow: 24 (GPM) Cur:0.01
ON:
Manual Station WED 5:43:40 PM