Manual

52
DXi User Manual
Chapter 7: Reports and Diagnostics
Sensor Board Status
The Sensor Status test displays critical information about each device attached to the
system.
Keypad Test
The Keypad Test is to confirm the buttons and Control Dial on the faceplate are
functioning properly. The test prompts the user to press each button as directed.
To bypass the test, touch nothing and the test will cancel within five to ten seconds.
Program Test
The Program Test turns on every station within a particular program for the specified
Duration (minutes: seconds).
to select a Program to test.
to set the duration for each station of the program in the test.
Start Now to start the Program test.
Previous to test the previous station again.
Next to switch to the next station in the program.
Flow 1: 5.0000 Hz
Flow 2: 5.0000 Hz
Flow 3: 5.0000 Hz
Rain: 16 pulses
Wind: 4.0000 MPH
ET: 3 pulses
Alarm 1-3: Op, Op, Op
Current: 1.0000 Amps
Sensor Status Status WED 5:43:40 PM
Keypad/Knob/LED - Test
Press: LT
Diagnostic Tests WED 5:43:40 PM
Test Program 001
Duration 00:07
Start Now
Previous Next
Status: Test Running: 11
Flow: 0 (GPM) Cur:0.02
Program Test WED 5:43:40 PM