Manual

34
DXi User Manual
Chapter 4: Setup
Firmware Update
Toro continually strives to enhance the performance and functionality of its
controllers. Occasionally, a firmware update might be necessary for your controller.
Steps
1. Download the latest firmware driver from Toro's website. Copy file to root drive
on a USB drive in folder labeled “FirmwareUpdate”. Be sure your DXi controller
is on.
2. Accessing the TM from the bottom, insert the USB thumb drive with the latest
firmware update on it into the USB slot.
3. The controller will display a message and beep to let you know it has detected a
USB thumb drive.
4. Navigate to Setup-->Page 2-->Firmware Update. .
5. The DXi will update the firmware. Once complete, the DXi will display reset.
6. Remove the USB thumb drive.
An instructional video on how to update firmware is located on the Toro
website, www.rainmaster.com.
Advanced
Advanced options specify what is connected to the controller's serial port and Comm
board ports. The devices connected via the Comm Option should be automatically
detected and set by the controller upon reset.
The rest of the ports should be set to Default unless one of the following is
connected:
• AC 2 Wire (hardwire) – for direct serial connection to a 2-wire gateway
• AC 2-Wire (19200) – when connected to a 2-wire gateway at 19200 baud
Firmware update complete
Firmware Update WED 5:43:40 PM
CONFIG(RIGHT)
Default
CONFIG(LEFT)
Default
COMM OPTION
Default
COMM OPTION SERIAL
Default
CTM Destination
Not Installed
Port Functions WED 5:43:40 PM