SDS

Nisus DSV Specimen Label • SAL102110 • page Page 16 of 18
RV HOLDING TANKS / RECREATIONAL VEHICLES:
For toilet waste and holding tanks, cover bottom of hold-
ing tank with water and 1 1/4 to 2 ounces per gallon of
water to deodorize. If odors return before time to empty,
add 1 1/4 to 2 ounces to the tank. For kitchen waste, add
1 1/4 to 2 ounces to gray water tank as needed to con-
trol malodors created by dirty dishwater.
FOR ODORS CAUSED BY DOGS, CATS AND OTHER
DOMESTIC ANIMALS: Use on rugs, floors, walls, tile,
cages, crates, mats, litter boxes, floor coverings, or any
surface soiled by a pet. Test a small inconspicuous area
first. Blot problem area. Then follow directions for “Gen-
eral Deodorization”.
GLASS CLEANING/DEODORIZING DIRECTIONS: Use
1 1/4 ounce per gallon solution (or equivalent use dilu-
tion) to clean and deodorize windows, mirrors, and glass
surfaces. Use a coarse spray device. Spray 6-8 inches
from surface. Rub with sponge or cloth. Do not breathe
spray.
WATERBED CONDITIONER: When used as a water-
bed conditioner, this product eliminates the odor caused
by bacteria. Prevents bubbles, preserves plasticizers,
conditions vinyl interior, sequesters minerals.
If bed has not been treated properly, drain bed
completely. Add 15 gallons of water, mix vigorously,
drain bed again. Fill bed with water and follow dosage
directions.
Dosage: To eliminate the odor caused by bacteria, add
10 fluid ounces in a free flow waterbed of 90 to 180 gal-
lon capacity. Add 10 fluid ounces in a waveless/fiber
waterbed mattress of 90 to 180 gallon capacity. Repeat
application every 4 to 6 months.
WATER/SMOKE DAMAGE RESTORATION
Effective against odor caused by water and/or smoke for
home, institutional, industrial and hospital use. This
product is particularly suitable for use in water damage
restoration situations against odor caused by water on
the following porous and semi-porous materials: carpets,
carpet cushion, sub floors, drywall, trim, frame lumber,
tackless strip and paneling. Saturate affected materials
with enough product to remain wet for at least 10
minutes. Use proper ventilation.
SEWER BACKUP & RIVER FLOODING: To rid affected
area of odors caused by sewer backup and river flood-
ing, dilute 2 to 4 ounces of this product per gallon of wa-
ter allowing for the diluting effect of absorbed water
within saturated materials. Remove gross filth or heavy
soil along with non-salvageable materials. Saturate all
affective areas with a sprayer using a coarse spray tip,
before and after cleaning and extraction.
CARPETS, CARPET CUSHIONS AND OTHER PO-
ROUS MATERIALS SUCH AS SUB FLOORS, DRY-
WALL, TRIM AND FRAME LUMBER, TACKLESS
STRIP AND PANELING: Effective against odor caused
by water damage. For water damage from a clean water
source, extract excess water. Test hidden area for color-
fastness. Dilute 2 to 4 ounces of the product per gallon
of water, allowing for the diluting effect of absorbed wa-
ter within saturated materials. Remove gross filth or
heavy soil. Apply directly with a sprayer using a coarse
spray tip, to fully saturate affected materials. Roll, brush
or agitate into materials and allow the materials to re-
main damp for 10 minutes. Follow with a thorough ex-
traction. Dry rapidly and thoroughly.
SPECIAL INSTRUCTIONS FOR CLEANING CARPET
AGAINST ODORS CAUSED BY BACTERIA: This
product can be used to deodorize carpets in industrial
and institutional, commercial and residential areas such
as homes, motel & hotel chains, nursing homes, schools
and hospitals. For use on wet, cleanable synthetic fibers.
Do not use on wool. Vacuum carpet thoroughly prior to
cleaning. Test fabric for colorfastness.
For Portable Extraction Units: Mix 2 ounces of this
product per gallon of water (or equivalent use dilution).
For Truck Mounted Extraction Machines: Mix
24 ounces of the product per gallon of water and meter
at 4 gallons per hour.
For Rotary Floor Machines: Mix 4 ounces of this prod-
uct per gallon of water and apply at the rate of 300-500
sq. ft. per gallon.
Do not mix this product with other cleaning products.
Follow the cleaning procedures specified by the manu-
facturer of the cleaning equipment. After using this prod-
uct, set the carpet pile and protect the carpet from
furniture legs and bases while drying. Do not over wet. If
applied to stain resistant nylon carpet, apply a fabric pro-
tector according to the carpet manufacturer’s directions.
CARPET CLEANI
NG / DEODORIZ
ER AGAINST ODOR
CAUSED BY BACTERIA, FOR HOME, INSTITUTION-
AL, INDUSTRIAL AND HOSPITAL USE: This product
cleans and deodorizes the carpet by eliminating odors
caused by bacteria. It can be used in industrial and
institutional, commercial and residential areas such
as homes, motels, hotel chains, nursing homes and
hospitals.
Vacuum carpet thoroughly prior to application. Mix
2 ounces of product per gallon of water (or equivalent
use dilution). Follow the injection and/or extraction pro-
cedures as specified for any conventional steam clean-
ing equipment you are using. For rotary floor machines,
mix 16 ounces per gallon of water and spray on carpet at
a rate of 300-500 sq. ft. per gallon.
For use on washable synthetic fibers. Do not use on
wool. Test colorfastness of carpet before use. Apply di-
luted product to a small, concealed spot, then rub with a
clean white cloth. If color changes or transfers to the
cloth, a water-based product must not be used.
After using the product, set carpet pile in one direction
with a stiff brush. Place aluminum foil under the legs of
furniture while carpet is drying. Over-wetting can cause
carpet to shrink. Manufacturer assumes no responsibility
for over-wetting misuse.