Installation Guide

710323-100 Rev. A
Recommended Tools & Materials
Tape Measure
Clear Silicone Caulk
& Caulking Gun
Level
Drop-In Countertop Sink
Models: DL-1 & DL-6
IMPORTANT: Unpack your new Drop-In Sink and inspect carefully for damage. Your new Drop-In Sink is made of SMC.
Exercise care during installation. Rough handling or dropped tools may chip or crack material.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2013
Thank you for selecting FIAT Products. To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
1
4
SAVE FOR FUTURE USE
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
3
2
OBSERVE LOCAL PLUMBING AND BUILDING CODES
INSTALLATION PLANNING
PARTS ILLUSTRATION
INSTALLATION PROCEDURE
Remove sink from opening
and install faucet (supplied
by others). Use flexible
supply lines where
permissible. If sweat
connections are required,
make all attachments before
the sink is in place. Install
drain plug by applying a
bead of silicone sealant to
the underside and tighted in
place as shown in Figure 2.
Wipe away excess sealant.
Connect supply and waste lines to faucet and drain respectively.
Apply a continuous 3/8" diameter
bead of sealant to the underside of
the rim as shown in Figure 3. Set
sink into countertop and fasten in
place with locking bars and screws
provided. CAUTION: Tighten
screws until locking bars contact
the underside of the countertop and
will not spin. DO NOT overtighten.
These sinks are designed
to fit into a standard cabinet
countertop.
Determine the desired location of your sink on the counter top.
Make sure the position will fit on the flat area of the counter
top taking into account the radius curve of the back splash
(if applicable). Also note clearance below the counter top to
assure room for faucet and drain connections.
FIGURE 3
APPLY SILICONE
SEALANT AT THIS
LOCATION ALL
AROUND UNDERSIDE
OF SINK RIM.
RUBBER WASHER
LOCKNUT 1-1/2" THREAD
SLIP NUT WASHER 1-1/2"
SLIP NUT 1-1/2"
This sink is designed to fit into a 23-1/8" x 20-7/8" countertop
cutout. Determine the desired location of your sink and lay out
the cutout dimensions as shown in Figure 1. Drill four (4) 1/2"
diameter holes at each corner of the cutout and make a saw cut
on the inside of the layout line. Test fit sink into opening.
CAUTION: DO NOT start cutout closer
than 1” from the countertop
radius as indicated
in Figure 1, Detail 1.
20-7/8"
(530mm)
23-1/8"
(587mm)
1" MINIMUM
(25mm)
1/2" DIA.
(13mm)
DETAIL A
FIGURE 1
FIAT
PRODUCTS
®
APPLY SILICONE SEALANT
UNDER DRAIN BODY FLANGE
RUBBER
WASHER
FIGURE 2
STOPPER
DRAIN PLUG
LOCKING BAR
(4 REQUIRED)
LOCKING SCREW
#8 x 1" LONG
(4 REQUIRED)