User Manual
Check the fit and trim more where needed.
You are going to have to lengthen the retract wires or use a servo extension. I lengthened the wires using a lead from a
couple of old damaged servos. I cut off the plug and soldered the longer wires on and insulated using small 3mm heat
shrink.
The landing gear wires I used are the Eflite wires for the P-47. I tried modifying the fixed wires but they were too short
when you cut them off at the bend. Also note there is a right and a left to wire struts and the coil fits on top and the
wheels are not toed in. You will need a couple of set screws for each gear since none come with the retracts.
LG wire struts will be in at a bit of an angle to allow for proper alignment when gear is deployed.