Installation Guide

IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before using
DANGER
- To reduce the risk of electric shock:
1. Always unplug this furnishing from the electrical outlet before cleaning.
WARNING
- To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids,or
disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped into water. Return the furnishing to a service center
for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never operate the furnishing with the air openings blocked. Keep the air openings free of lint,
hair, and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
10. To disconnect, turn all controls to the off position, then remove plug from outlet.
11.
WARNING
: Risk of Injury - Keep children away from extended foot support (or other
similar parts).
12.
WARNING
: Risk of Electric Shock - Connect this furnishing to a properly grounded
outlet only. See Grounding Instructions.
13. For loading always put heavier items at the bottom and not near the top in order to help prevent
the possibility of the furnishing tipping over.
14.
WARNING
: Risk of Injury to Persons - do not place video equipment such as televisions
or computer monitors on the product.
15.
WARNING
: Risk of Injury to Persons - do not use this furnishing to support video
equipment such as televisions or computer monitors.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring system, or an
equipment-grounding conductor must be run with the circuit conductors and connected to the
equipment-grounding terminal or lead on the product.
SAVE THESE INSTRUCTIONS
1