Manual

Sensor connection and operation:
To connect a rain sensor, remove the jumper wire from the sensor terminal and
connect one wire of the Toro RainSensor
TM
to the C-common terminal and the other
wire to the N.C. (normally closed) terminal. As soon as the Toro RainSensor
TM
contacts change from the N.C. position to the N.O. (normally open) position,
irrigation will be suspended. Irrigation will resume as soon as the Toro
RainSensor
TM
dries and its contacts return to the N.C. position.
When irrigation is suspended due to the Toro RainSensor
TM
, the display shows:
OFF
NOTE: When using the Toro RainSensor
TM
, follow the Basic Connection
Installation Instructions supplied with the Rain Sensor.
-5-
RESET
SENSOR
SENSOR
9 volt
Battery
Install in a
protected area.
TRANSFORMER
Quick Ref.
Card