Users Manual

Instructions:
Connect the controller to the electric kid’s car with wire and turn on the car and
controller at the same time.
Coding the controller and receiver when control with the remote controller. When
the remote controller first turns on, the top light flashes slowly and then turns on
the receiver. When the light long bright, it means coding finishes and you can
turn on the car.
There are 6 buttons on the remote controller:forward, backward, left, right,
Speed Conversion , stop. The power button is used as the power supply when
the remote controller is stand-by. When the remote control is working.
1. Turn o ffthe Power Switch on the car.
2. Remove the battery cover on the Remote Control and put in 2 AAA
battery, the three LED indicators will flash.
3. Turn on the Power Switch on the car, when the LED indicators stop
flashing and 2 of them are on, matching successes.
4. Once the matching is made, there is no need to match code again
only if the battery is replaced.
5. The Remote Control will enter a sleep mode if not used for a long time
and the LED indicators will be off. Press any buttons to wake up the
Remote Control, and it can be used normally.
Button Description: ▲: forward ▼: reverse ◀: turn left ▶: turn right
S: Speed P:emergency brake, press it and the running function will fail,
press again, it release.
2.Matching the frequency of car and remote control
Remote control operating instruction
Remote control is priority (when the car is in Remote control, the remote
control personnel can control the car forward and backward, high/Low
speed, steering and other functions, the driver CAN NOT operate the car).
Press the ▲ forward button, the car goes forward.
stop key
back key
front key
speed indicatiors
speed select key
left key
right key