Instructions / Assembly

BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE
CIRCUIT BREAKER IS SHUT OFF. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on
house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read
instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician. NOTE: Proper wiring is essential for the safe
operation of this fixture
(Refer to Figure 1, 2,) The weight of this fixture will require means of support independent of the OUTLET BOX. This a fixture must be
supported by 4/8-18 NPSM NIPPLE (supplied) The NIPPLE should be positioned so that3/4" protrudes into the OUTLET BOX cavity. Note:
the opposite end of the NIPPLE must be attached to a structural or bridging member of sufficient strength to support the fixture weight. A
COTTER PIN has been included and should be installed into the top of NIPPLE, above HEX NUT for added safety. A clearance hole must
be drilled on the inside top center of the OUTLET BOX. Please refer to Figure 2 for detailed illustration. We recommend the consultation of
a licensed electrician or contractor due to the complexity of this installation.
IMPORTANT: Do not attach fixture directly to outlet box.
STEP 1: Assemble the MOUNTING THREAD NIPPLE with MOUNTING STRAP and the 4/8-18 NIPPLE into the COUPLING until tight,
tighten the SET SCREWS with screwdriver to secure the COUPLING to NIPPLES. Proceed to insert the 4/8-18 NIPPLE into the OUTLET
BOX CENTER HOLE up to the WOOD BRIDGING MEMBER, (See FIGURE 1 and 2)
STEP 2: Secure the MOUNTING STRAP on the OUTLET BOX with BOX SCREWS. Tighten the 4/8-18 NIPPLE on WOOD BRIDGING
MEMBER WITH WASHER, HEX NUT WITH SHAKE PROOF WASHER(INCLUDED), Using a COTTER PIN insert into the 4/8-18 NIPPLE
protrude top, See the FIGURE 2
STEP 3: Fasten the Mounting frame to the ceiling as per the PAGE 1 instruction.
Refer to Figure 1.2) This fixture is provided with Safety Cables as well. The Safety Cable provides a backup system the
mounting frame and the installation hardware. It is essential that the Safely Cable be properly installed. The Cable must be
secured to a STRUCTURAL MEMBER of the building, and not to the outlet box. The Cable must be terminated with steel
cable lock kit specifically sized for the Cable per the following steps:
1. Insert enough cable through a hole of lock bushing
2. Attach the safety Cables from mounting frame to the Structural Member of building directly.
3.Wrap the Cable around the building Structural Member as many as you can, then pull the safety cable end tight, inserting into the other
one hole of lock bushing, secure the two screws tight into the lock bushing with screwdriver. Make sure the safety cable doesn't slip back.
This is a sketch for only Safety Cable mounting, The Cable must be secured to a STRUCTURAL MEMBER of the building, and
not to the outlet box.
Remark: Please make sure all hardware is properly tightened and that the cable is positioned dear of any obstructions!
Carefully remove the fixture from the carton and check that all parts are included as shown in FIGURE 1.2. Be careful not to misplace any
of the screws or parts which are needed to install this fixture.
Hook the mounting steel cables from the fixture ceiling pan on the mounting frame for making wire connections.