Installation Guide

INSTALLATION GUIDE
READ BEFORE INSTALLATION
Easy cover is a covering easily installed comparing with other covering. Following our
instructions, you will get outstanding results in just a few minutes.
1.) Clean the wall and remove any nails etc.
2.) Measure the wall carefully and draw a horizontal line, using the spirit level, on all the walls
of the room, marking the center of the wall.
3.) Repeat the procedure drawing a vertical line on each wall, thereby drawing a cross on all
walls.
4.) Installation of the tiles on each wall should begin from the center of each cross.
5.) Remove the protective film from the tile and apply a small quantity of EASY COVER
adhesive on each of the marked areas.
6.) Carefully stick the tile right in the 90° quarter which has been marked in the center of the
wall, gently pressing the edges and the center using the same pressure.
7.) Lay the next/adjacent tile in the same manner.
8.) To lay the lower tile, measure the center of the tile and make a small pencil mark. Glue the
tile in place.
9.) Follow the same procedure with the upper tile.
10.) Once the four ‘guide’ tiles are in place, the first line of tiles should be glued on, followed
by the other two lines.
11.) Follow the same procedure for the other lines, always starting from the centre of the
master line.
12.) When you reach the edge of the wall, measure the distance from the last tile to the wall
and mark how much of the tile to cut.
13.) In order to cut the tile, draw a line. Put a set square or metal ruler on the line, run a
Stanley knife gently along the line about three times. You can also use scissors.
14.) Break the tile into pieces by pressing from the center out to the opposite edges of the
piece and finish off cutting the foam with the stanley knife.
15.) In order to lay the pieces of the top and bottom parts of the wall, measure each one of the
tiles to be cut, and then follow the cutting instructions previously explained.