Installation Guide

SURFACE PREPARATION
Self-adhesive vinyl tiles can be installed on surfaces below described:
Wood. (OSB, wood strip, okumen plywood..) It is important to remove any rest of varnish or
paint that can be detached once installed the coating.
Plasterboard. It is recommended to apply a coating before installing the EASY COVER
Metallic surfaces. (Aluminum, iron, steel,)It is needed to remove paint or varnish first, and
applying a properly cover to stabilize the surface.
Gypsum surfaces. A layer of painting or covering is needed before the installation.
Other surfaces. Contact with your supplier.
The surface must be cleaned, free from oil, dust or other substances that might be detached
once tiles installed.
Remove any rest of wallpaper, flaky painting, varnish, etc...
Repair, if necessary, any gap on the surface in order to avoid any slope.
TOOLS YOU WILL NEED (NOT INCLUDED)
A spirit level, a tape measure, pencil, Stanley knife or scissors.