Installation Guide

Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
Low Prole LED Canopy
Installation Instructions
Models: CMS1/CL33BZ50/LED (99913)
CMS2/CL58BZ50/LED (99914)
IMPORTANT
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING - Risk of re or electric shock.
WARNING - Make certain power is switched OFF before starting
installation or attempting any maintenance. Consult
an electrician if not qualied, to prevent electric shock.
WARNING - This luminaire is not intended to use for emergency lighting.
Application/ Use:
This product is UL listed for use in wet locations. It is not intended for use with dimmers.
Installation steps:
®
© 2015 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change.
1. Remove the junction box mounting plate from the top of the xture by
loosening one side screw and sliding the xture plate out from the holding
brackets on the top of the casting.
2. Install the mounting plate to the junction box with two screws (not provided).
The bracket should be positioned to allow the xture to be “square” with the
sides of the canopy the xture is mounted to.
3. Hang the xture from support spring while wiring the unit. Bring the xture
input wires from the top of the xture and connect to the power leads in the
junction box – black to black (hot), white to white (neutral), and green to
green (ground).
4. Connect the main housing to the junction box bracket. Hold in place while
reinstalling one side locking screw.
5. Turn on the power. The xture will come to full output in several seconds.
NOTE: Do not remove the bottom lens or touch the LED optics. All LEDs are
preinstalled and ready to operate.