Installation Guide

Farmhouse Apron Sink Stainless Steel Sink

INSTALLATION INSTRUCTIONS

General Recommendations:

Read installation and maintenance instructions thoroughly before installing sink.

Be sure to use proper tools and always wear proper personal safety accessories for your

protection.

Prior to Installation:

• Inspect the sink prior to installation to make sure the sink has not been damaged during

shipping

• Use the cut-out template provided.

• Additional floor and wall preparation may be required to avoid damaging the product

• Make sure to purchase the correct cabinet for your farmhouse sink. Farmhouse base

cabinets should be 3” larger than the actual size of the sink

• Not recommended to be installed with laminate countertop

Tools and Material Needed for Installation:

NOTE: Specialized tools may be necessary to install Stainless Steel Undermount sinks with

countertop materials other than wood, marble, or granite.

PAGE 1
Farmhouse Apron Sink Stainless Steel Sink INSTALLATION INSTRUCTIONS General Recommendations: Read installation and maintenance instructions thoroughly before installing sink. Be sure to use proper tools and always wear proper personal safety accessories for your protection. Prior to Installation: • Inspect the sink prior to installation to make sure the sink has not been damaged during shipping • Use the cut-out template provided.
PAGE 2
1. Measure & Build Supports • Measure the actual height of apron • Build supports on inside of cabinet based on sink measurements Installer Tip: Support Options • 1 1/4” Angle Irons • (2) 2”x 4’ • 3/4” Plywood 2. Cut Cabinet Front • Measure height of apron front. Add 1/16” to the dimension when you mark base cabinet front cutout. Use jigsaw to cut.
PAGE 3
. Install Sink • Place sink in opening. The weight of sink should be sustained by the built supports • Make sure sink is leveled from front to back and side to side • Uses silicone to fill in gaps where necessary 4. Cut Countertop • Use a bead of silicone (or preferred adhesive) around the rim of the sink. Check the alignment of the sink to the cutout in the countertop.
PAGE 4
5. Installing Plumbing Fixtures • Connect drain, trap to drain and water supply connections to the faucet according to manufacturer’s instruction.