Instructions / Assembly

ManualsBrandsUnbranded ManualsGolf Equipment120 in. x 120 in. Heavy-Duty Golf Net Baffle Protects Golf Netting

5x10x10 Golf Net with Frame

SAFETY REMINDERS:

1. Keep pets and unsupervised children away.

2. Keep spectators out of swing range.

A 3-Way Corner 6

Please review the parts you received to be

sure you have all the parts.

For these instructions the "back" of the

cage is the side the impact screen hangs

parallel to.

The "front" is the side that does not have

a pole at the bottom.

B 2-way Corner 2

C Baffle Tee 2

D 10' Pieces of 1" EMT 10

E 5' Pieces of 1" EMT

(1 - 10' Piece cut in half)

F Golf Net 1

G Impact Screen 1

H Net Hangers 5

1. Lay out the four top 3-Way Corners (A) into a 5'x10' square. Lay the EMT, 2 (D) and

2 (E), between the corners.

2. Prepare the poles by sliding the Baffle Tee (C) onto opposing EMT poles (E). Make

sure the eye-bolts are facing up. Also, lay another piece of EMT (D) between the

Baffle Tees (C).

3. Assemble the top by inserting the poles into the Corners (A). Start with one of the

poles with a Baffle Tee (C), and slide the corners over each side. Make sure the

corners point down and in. Now move on to the poles (D) that are perpendicular to

the Baffle Tee pole (C). Insert all 3 poles into the Corners (A) and the Baffle Tee (C).

Slide on the final two corners and place the remaining EMT (E) with the Baffle Tee (C)

into those corners. You should now have a closed square with a pole in the middle.

4. Tighten the Corners (A) onto the EMT (D) and (E). Hand tightening should be

sufficient, it just supposed to keep the poles from sliding. Do not tighten the 2 Small

Tee eye-bolts on the outside pipe. This will allow you to easily adjust your Impact

Screen location.

5. Attach the Legs by inserting 4 pieces of EMT (D) into the Corners (A). Tighten the

Corners (A) onto the EMT (D) legs.

6. Attach the bottom Corners (A & B) to the left EMTs (D) you just secured. Make sure

the 2-Way Corners are at the front, opposite the baffle and pointing towards the rear.

7. Connect the corners with the remaining 3 pieces of EMT 2 (E) and 1 (D). And tighten

the corners onto the pipes.

8. Lay out your net (F) inside the frame. Find the 2 s-hooks with red tabs. That is the

top, front of the net. The other color signifies the top back of the net. The netting

should rest on the loose cord (front to back as indicted by the black dotted line on the

diagram) to create your top edges.

9. Hang your net (F) by hooking the s-hooks through the rings on the corners.

10. Attach your Impact Screen to the cross bar with Net Hangers (G).

The pole/pipe we recommend is 1" (ID) EMT (Electric Metallic Tube) conduit and will be located

in the electrical section of your local home improvement center.

At Home Depot it's Model #101568 - Store SKU #580015

At Lowes it's Item #72715 - Model #101568