Use and Care Manual

with Hillyard Assurance® add four ounces per gallon of hot water. Assurance will
remove animal fats, blood, vegetable oils and other stubborn stains found in commercial
kitchens. USDA approved, A4.)
3. Place wet floor signs on area to be cleaned.
4. Dip a clean synthetic mop into the cleaning solution. Wring out the mop to the point
it's well saturated, but not dripping. IMPORTANT: Do not use the kitchen mop to clean
the dining area.
5. Mop a 10 x 10 ft. area in a figure 8 motion. Turn mop over as one side becomes
soiled.
6. Place mop back into mop bucket, moving it up and down in the cleaning solution.
Wring out excess.
7. Mop the next 10 x 10 ft. area.
8. Continue this same procedure until the entire floor is clean. Remember to change the
cleaning solution as it becomes dirty.
9. Clean all corners and door jams.
10. When finished, thoroughly rinse mop, bucket and wringer with clean water. Return
clean equipment to proper storage area.
At least once per week, and more often if necessary, the floor should be scrubbed with
a solution of Hillyard Assurance®, all-purpose cleaner and a scrub brush. NOTE: For
faster results, a single brush floor machine equipped with a scrubbing brush is
recommended. Weekly Floor Scrubbing Procedures are required for
QUARRYBASICS® XA Abrasive Series in Order to Keep the Floor Clean and Safe.
Weekly Floor Scrubbing:
Sweep entire area of floor to be scrubbed with a broom. Use dust pan to pick up dirt and
debris. Fill a utility bucket to the two gallon mark with hot water and add four ounces of
Hillyard Assurance®. Place wet floor signs on area to be scrubbed. Pour approximately
one quart of the cleaning solution onto the floor. Scrub a 10 x 10 ft. area with the swivel
scrub brush by applying downward pressure in a back-and-forth motion. Pay particular
attention to the grout joints. After the section has been scrubbed in both directions, push
the cleaning solution with the water wand (squeegee) to the nearest floor drain. NOTE:
For faster results, pick up scrubbing solution with wet vac. Fill a clean mop bucket with
clean water and damp mop rinse the section which has just been scrubbed. For the
QUARRYBASICS XA Abrasive Series the use of a nylon/poly looped end mop ((such as
Wilen's Rough Rider, phone [phone]
www.continentalcommercialproducts.com or Ha-Ste Manufacturing Inc.'s RuFFloor
Looped End Wet Mops, phone [phone] www.hastemops.com for closest dealer)
is suggested. Be sure to change rinse water frequently to help ensure all residue is
removed. Following the procedures outlined, continue until the entire floor has been
scrubbed and rinsed.
Above all Else, You Can’t Keep a Floor Clean with Dirty Equipment. Rinse mop
thoroughly by running clean, hot water through the mop head at the utility sink. Twist the
mop in the wringer and wring out as much water as possible. Hang the mop upside
down to air dry. Always rinse out mop bucket and wringer with clean water.