Instructions / Assembly

Board Features
Competition grade drop-stitch PVC technology and can inflate up to 8-15 PSI
3 FIN Set UP: 2 lateral and 1 central fin
Includes: SUP, ALUM paddle, high pressure hand pump, backpack, and
repair kit.
INFLATION INSTRUCTIONS:
The SUP is fitted with an industry standard valve with a simple push
button system:
Valve pin should be UP for inflation (Vertical to the SUP surface)
which ensures that when you inflate to around 12
PSI all the air does not leak
out. This is very important as you may be
tired after spending 7-10 minutes
inflating your board and 50% of the air leaks out in seconds.
Take the board from the box or ventilated storage bag and release security/
storage strap, un-roll the board with the Deck Pad UP and the Fins Down.
The pump is a single action pump with an in-line pressure gauge.
The pump is also supplied with a flexible hose with bayonet connectors that
fit directly into the board valve and the pump connector.
IT IS NOW TIME TO “PUMP IT UP”
The first time you inflate your SUP will require more effort than subsequent
inflations
Make sure you keep your hands toward the center of the pump handles when
pumping and your feet firmly on the foot rests and pull up and push down
directly over the pump shaft.
Inflation Recommendation:
You will find that you will reach 10 PSI in about 4-5 minutes. Take a break if
you need.
Do not over inflate. The maximum pressure recommended is 12-15 PSI.
DEFLATION INSTRUCTIONS:
**There is no need to deflate your SUP after each use unless you
need to pack the board into your back pack for transportation. Your
SUP can remain inflated all season.