Instructions / Assembly

As shown in figure 3, insert 12” arm support into hole in arm,
then into hole in the top of the seat end. Drive the dowels in as
far as possible.
Fasten arm to frame from the back by tightening the preinstalled
lag screw into the pilot hole in the arm with a 7/16” wrench. Re-
peat the process for the other arm.
Secure all dowel joints that you have assembled in place with
screws perpendicular to the doweled end as shown in figure 4.
Figure 1
Figure 3
Figure 2a
STEP 1
STEP 2
STEP 3
STEP 4
Put barrel nut into horizontally
drilled hole in end of swing bar.
Position barrel nut with screw-
driver and screw in 5” eyebolt
with 3/8” washer as shown in
figure below. TIGHTEN
DOWN SECURELY! Repeat
process for other swing bar.
Fasten swing bars to side of unit as shown in figure 5. Measure 15”
from the back of each arm and mark with pencil. (This gives a sug-
gested pitch of the seat. You may change the pitch by altering the
location of the lag screw in the arm.) With hammer tap a 5” hex
washer head screw through the bottom hole in swing bar and into pilot
hole on seat end. Tap a 5” hex washer head screw through the upper
hole in the swing bar and into the arm about 1/2” deep at the place
marked on the back of the arm. Tighten down lag screws.
STEP 6
Figure 5
If you have hardware left over after completing your unit it most
likely has been assembled incorrectly and may not be safe to use.
Please call customer service at 1-800-427-5136, for assistance.
Check all nuts and bolts for tightness
before and during each usage season.
Factory: 1 Lakeland Place, Edmore MI 48829-0350, Phone: [phone], Fax: [phone]
www.lakelandmills.com
Figure 2
STEP 5
Install seat end onto seat. Align holes in seat end with dowels on
seat as shown below. Repeat on other side. Secure with screws
perpendicular to dowel. IMPORTANT: The single hole should be
placed toward the front of the seat. (See below).
Figure 4
Making sure the holes in the uprights of the assembled back is
facing in. Place one of the backs into the holes in the assembled
seat. Insert table supports into holes in the front of the table. In-
sert table supports into the holes in the table front and into the
upright of the back you have already inserted. Lay assembled
seat on ground. Insert dowel end of uprights on assembled seat
back into 1-1/4” holes on the back seat rail, adjusting uprights in
or out as needed to align properly. Insert table supports into
holes on front of seat rail. See figure 2a. DO NOT tap on seat
back with hammer. To keep the SEAT RAIL from splitting, lay
the back on the ground and drive the seat on by hitting on the
bottom of the seat assembly. As shown in figure 2b.