Instructions

Mounting of the F-connectors
smart Mobile Sat System 29
1.
Strip the coaxial cable at both ends as described in Figure 9.
2.
Slide the rubber grommet on the coax cable before mounting the second F-connector.
The opening with the larger diameter must be facing the end of the cable.
3.
Screw the F-connector as shown in Figure 9 on the coax cable.
Figure 8: Construction of the coaxial cable
No.
Description
1
Sleeve
2
Wire mesh and aluminum foil
3
Dielectric
4
Inner conductor
Original condition of the coaxial cable.
Remove 8mm of sleeve, wire mesh including
aluminum foil and dielectric. Be careful not to
damage the inner conductor.
Carefully remove about 10 mm of the sleeve, so
that aluminum foil and wire mesh are exposed.
Turn the wire mesh and aluminum foil back-
wards so that it's not touching the inner con-
ductor. Now remove the insulation (dielectric)
under the mesh, so that only the inner conduc-
tor can be seen.
Turn the F connector on the backwarded wire
mesh until the insulation touches inside the F-
connector.