Use and Care Manual

8
For more information and technical assistance [e-mail] or please visit us at www.bullyliner.com
E. Using a Paint Brush & Roller Properly (Continue)
6. Repeat the application process for the second coat (steps 1-5).
7. After second coat is dry to the touch, check for any missed spots
and touch up.
8. Install tailgate and hardware.
9. The truck bed will be ready for light use in 10-12 hours.
10. Clean all tools using water before BULLYLINER has dried.
F. Using BULLY HVLP Spray Gun Properly
1. Connect to an air compressor with a pressure of 50-60 PSI. (Higher pressure will provide a smoother
finish.) Before starting the job, test spray the gun away from truck bed to become familiar with the
spray pattern and coverage.
2. Spray an even coat over the entire surface to be covered in a quick, “S”-shaped motion.
Be careful not to apply coat too thickly. Apply a thin, uniform coat of BULLYLINER to the entire truck
bed. Do not apply too thickly to prevent running and drips.
3. Wait about an hour or two, or when surface becomes tacky, then apply a second coat. (Failure to
apply two complete uniform coats will compromise the durability and reduce the longevity of the
BULLYLINER truck bed coating.)