Use and Care Manual

6
For more information and technical assistance [e-mail] or please visit us at www.bullyliner.com
D. APPLYING BULLY RUBBER COATING (Using Bully Spray System)
For best results, use:
BULLY Spray Gun
1. Use undiluted and apply onto the prepared surface. Two coats
is recommended for normal truck bed use. Apply unlimited,
additional coats for heavy duty use.
2. Putting down your first “tack” coat. A “tack” coat is a light coat
of material, gently sprayed onto the surface to establish good
adhesion.
3. Allow the tack coat to dry to the touch before applying
additional coats. Depending on temperature and humidity,
allow (10 -15) mins in 15c° up
NOTE: Do Not apply material on too thick per coat or
cracking will occur. Allow each coat to dry to the touch
before additional coats. (Spray at 40 psi using the Bully
PP Gun System)
Do Not Apply below 10c° temperature
WARNING: KEEP OUT OF REACH OF CHILDREN.
Stir or shake the container to mix any settling of
material.