Instructions / Assembly

10
For more information and technical assistance [e-mail] or please visit us at www.bullyliner.com
G. Bully Pressure-Pot Spray System (Cont.)
1. Connect to an air compressor with a pressure of 50-60 PSI.
(Higher pressure will provide a smoother finish.) Before starting
the job, test spray the gun away from truck bed to become
familiar with the spray pattern and coverage.
2. Spray an even coat over the entire surface to be covered in a
quick, “S”-shaped motion. Be careful not to apply coat too
thickly. Apply a thin, uniform coat of BULLYLINER to the entire
truck bed. Do not apply too thickly to prevent running and drips.
3. Wait about an hour or two, or when surface becomes tacky, then apply a second coat. (Failure to
apply two complete uniform coats will compromise the durability and reduce the longevity of the
BULLYLINER truck bed coating.)