Installation Guide

6
Installation and Operation Guide
www.blueairfse.com
8) Electrical requirements
“There are several factors that will affect the proper
operation of your refrigerator. Among these factors, the
electrical installation is the most important and should
always be checked before connecting your refrigerator as
follows: “
1) Make sure the electrical installation complies with
national, state, and local codes.
2) Make sure the circuit is properly grounded.
3) Check circuit for proper voltage at receptacle.
4) Make sure that the wire gauge and breaker sizes are
correct and comply with the minimum allowance for
voltage drops (rated ±10%)
3. Operation Guide
1) Temperature control range of appliances:
MODEL Temperature
BSR23/23T/23G-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BSR49/49T/49G-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BSR72/72T-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BSF23/23T-HC
Hold -10Ｆ(-23.3
℃
)
BSF49/49T-HC
Hold -10Ｆ(-23.3
℃
)
BSF72/72T-HC
Hold -10Ｆ(-23.3
℃
)
BLUR28,36,48,60,72-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BLPT28,36,48,60,72-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BLMT28,36,48,60,72-HC
Hold 33Ｆ~ 38Ｆ(0.5
℃
~ 3.3
℃
)
BLUF28,36,48,60-HC
Hold -10Ｆ(-23.3
℃
)
2) Operations
• Connect the power to the unit, the display panel will
light up, and the compressor will begin to run.
• The compressor is automatically cycled by the
electronic controller.
• The interior light is activated by the door switch when
the door is open. (applies only to reach-in models)
• Evaporator fan motors will run after all doors are
completely closed. (applies only to reach-in models)
3) How to set the temperature
▶ To u ch the lock button for 3 seconds to
adjust the temperature.
▶ Adjust the temperature to the value you
desire by touching the or buttons.
▶ When you have finished adjusting the
settings, leave it for 3 seconds. Then the
changes will be applied.
☞ Default set temperature
▶ Refrigerator(Cooler) : 35°F(2°C)
▶ Freezer : 0°F(-18°C)
Icon and “DF” will show up while defrost cycle.
Icon will show up when evaporator fan(s) are in
operation
Icon will show up when compressor is in
operation
Icon will show up either Celsius or Fahrenheit
depending on operation setting.
Buttons to adjust setting temperature.
Icon is used to unlock the buttons.