User Manual

Programming Automatic Irrigation:
Tap and select Cyclic or Weekly program.
For the weekly program:
1. Set the irrigation duration
run time. It defaults to 5
minutes but this can be
changed by tapping on
the icon.
2. Tap on Start times and
select desired start time.
3. If not already a
checkmark, tap the X to
activate start time.
4. Toggle slider to Active.
Click Save.
5. Select desired days of
week to operate.
6. Click Send to store the
program.
For the cyclic program:
1. Set the irrigation duration
to run.
2. Select how often the
program runs. This can
either be days or hours.
3. Select start time of cycle
and day of week to begin.
4. Click Save then Send to
store the program.
Manual Irrigation:
1. From the status screen, press the Start icon ( ).
2. Press the time and set the duration in hours and minutes. Press Start.
3. The status screen counts down the time left.
It is possible to stop manual irrigation by tapping Close in the status screen or in the manual screen
then tapping the Close icon ( ).
Manual irrigation does not affect the existing irrigation program.
The program will continue as usual once manual irrigation ends.
Manual operation time display.
Suspend Controller
To suspend irrigation operation in the event of rain, fog, etc. without deleting the existing program, do the following:
1. Tap “Suspend Irrigation” slider to
Yes.
2. Set the number of inactive days,
or slide to “Unlimited”.
Press Save then Save again.
3. The status screen displays
Device not active with the “Not
active until...” end date.
Delete Controller
• In Settings, press the “Delete Controller” slider to Yes. Press Save and conrm deletion.
• From the Welcome screen, tap the Trash can icon ( ) by the paired controller and conrm.
Note: To reconnect, follow the pairing procedure at beginning of instructions.
Troubleshooting: If Controller Connection is Lost or Dropped
Press Scan for controllers button until the paired controller’s Bluetooth icon ( ) reappears.
Manual operation counting down.