Installation Guide

6
W30 & W30G CONNECTORS CONECTORES W30 Y W30G
W30 – Common connection of 2, 3 or 4 solid conductors No.14 or No.12 AWG.
W30 - connexion standard de 2, 3 ou 4 conducteurs massifs no 14 ou no 12 AWG.
W30 - Conexión común de 2, 3 ó 4 conductores sólidos AWG No.14 o No.12.
W30G – For connection of equipment grounding of 2, 3, or 4 solid conductors
No.14 or No.12 AWG.
W30G - pour la mise à la terre d'appareils comportant 2, 3 ou 4 conducteurs
massifs no 14 ou no 12 AWG.
W30G - Para conexión de tierra de equipo de 2, 3 ó 4 conductores sólidos AWG
No.14 o No.12.
Rating – 300 volts maximum, 20 AMP. 105° C maximum.
Calibre - 300 V maximum, 20 A, 105 °C maximum.
Calibre. Clasificación - 300 voltios máximo, 20 AMP. 105° C máximo. Calificación.
S
TR
IP
GA
G
E
A. Strip wire ends to width of product (1/2"
[12.7mm]).
 
(1/2" [12.7mm]).
 

pouce [12,7 mm]).
B. Insert wire ends the full stripped distance.
 
los cables.
 
connecteur.



 
connected directly to the service grounding terminal through an insulated grounding conductor on
the feed. The grounding circuit will not be isolated if the green harness conductor is connected to the
raceway base. The raceway base section is grounded through the use of a feed conduit or through

(available separately).
 


conectado a la base de la canaleta. La sección de la base de la canaleta se conecta a tierra usando el








Feed Wires
Alimentation
Cables de
alimentación
Ground Wire

Cable a tierra

Base
Base
Base

Install the cover.
Engage the lower bead of the cover into the base. Starting at one end and
progressing along the unit, snap in the upper bead, striking sharply with the
heel of the hand.
Monter le cache.
Encastrez le bord rond inférieur du cache dans la base. En commençant d'un
côté et en continuant progressivement le long de l'unité, clipsez le bord rond
supérieur en donnant des coups secs avec le talon de la main.
Instale la cubierta.
Acople la moldura inferior de la cubierta en la base. Coloque a presión la
moldura superior, empezando por un extremo y continuando a lo largo de
toda la unidad, golpeando firmemente con la parte baja de la mano.