Installation Guide

SAFETY NOTICE
DANGER - RISK OF FIRE OR ELECTRIC SHOCK
1. WARNING – Risk of fire or electric shock. Luminaire wiring and electrical parts may
be damaged when drilling for installation of LED retrofit kit. Check for enclosed wiring
and components.
2. WARNING – Risk of fire or electric shock. LED Retrofit Kit installation requires
knowledge of luminaires electrical systems. If not qualified, do not attempt
installation. Contact a qualified technician.
3. WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that
have the construction features and dimensions listed in this Manual.
4. Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
5. WARNING – To prevent wiring damage or abrasion, do not expose wiring to edges
of sheet metal or other sharp objects.
6. WARNING – To avoid potential fire or shock hazard, do not use this retrofit kit in
luminaires employing shunted bi-pin lampholders. Note: Shunted lamp holders are
found only in fluorescent luminaires with Instant-Start ballasts. Instant-start ballasts
can be identified by the words “Instant Start” or “I.S.” marked on the ballast. This
designation may be in the form of a statement pertaining to the ballast itself, or may
be combined with the marking for the lamps with which the ballast is intended to be
used, for example F40T12/IS. For more information, contact the LED luminaire
retrofit kit manufacturer.
7. Installers should not disconnect existing wires from lampholder terminals to make
new connections at lampholder terminals. Instead installers should cut existing
lampholder leads away from the lampholder and make new electrical connections to
lampholder lead wires by employing applicable connectors.
Always use UL approved wire nuts when bypassing ballasts and re-wiring fixtures.
DO NOT USE WITH DIMMERS.
SUITABLE FOR DRY LOCATIONS ONLY.
THIS PRODUCT IS NOT DESIGNED FOR USE WITH EMERGENCY EXITS.