Instructions / Assembly

Tamper-Resistant
Screw
Holster
Cadence Instrument
Assembly
Instrument Post
Access Panel For
Debris Removal
2" Tamper-Resistant Screw
Holster
Dual Drive
#2 Screw
Instrument Back
W/ Predrilled Holes
HOLSTER AND INSTRUMENT TO POST INSTALLATION PROCEDURES
Step 1:
Align Holsters to the instrument back with the corresponding arrows and letters. Fasten Holster to back with the provided dual drive screws.
Backs are predrilled. Screw heads should be flush with the Holster surface when properly installed. Holster must also be flush along the back.
An extended square drive or Phillips will be needed. Drive screws in slowly to prevent stripping.
Step 2: (Recycled Post Only)
With two people, situate the instrument onto the posts. Predrill 1/8" pilot holes into the posts through the existing holes on the
instrument holster. Fasten the instrument to the posts with the provided 1 1/4" tamper-resistant screws and security driver.
(Steel Post Only)
With two people, situate the instrument onto the posts. Predrill 11/64" pilot holes into the posts through the existing holes on the
instrument holster. Next tap the holes with the provided 10-24 Tap, the Tap may be used with a cordless drill. Last fasten the instrument to the posts with
the provided 1" tamper-resistant screws and security driver.
Step 3:
The Cadence comes equipped with an access panel to remove possible debris buildup within the instruments resonator. To remove and gain access
use the provided security driver to remove the (4) tamper-resistant screws.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
FREENOTES HARMONY PARK IS
PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
EMAIL: [e-mail]
WWW.FREENOTESHARMONYPARK.COM
SHEET 6 OF 6
SCALE: 1:6
PRODUCT SHEET / INSTALLATION GUIDE
CADENCE 2016