Product Manual

19
1
3
6
12
Hydraulic
1
Check the hydraulic cylinder(s), piston for damage noise and leakage
•
2
Check the hydraulic joints for damage and leakage
•
3
Inspect the hydraulic oil level, refill if necessary
•
4
Refill the hydraulic oil ( 12 month or 1500 working hours )
•
5
Check and adjust function of the pressure valve (3300lbs(BALLYPAL33N)+0/
+10% or 4500lbs(BALLYPAL45N)+0/+10%)
•
Mechanical system
6
Inspect the forks for deformation and cracks
•
7
Check the chassis for deformation and cracks
•
8
Check if all screws are fixed
•
9
Check the push rods for deformation and damages
•
10
Check the gearbox for noise and leakage
•
11
Inspect the wheels for deformation and damages
•
12
Inspect and lubricate the steering bearing
•
13
Inspect and lubricate the pivot points
•
14
Lubricate the grease nipples
•
Electrical system
15
Inspect the electric wiring for damage
•
16
Check the electric connections and terminals
•
17
Test the Emergency switch function
•
18
Check the electric drive motor for noise and damages
•
19
Test the display
•
20
Check, if correct fuses are used
•
21
Test the warning signal
•
22
Check the contactor(s)
•
23
Check the frame leakage (insulation test)
•
24
Check function and mechanical wear of the accelerator
•
25
Check the electrical system of the drive motor
•
Braking system
26
Check brake performance, if necessary replace the brake disc or adjust the air gap
•
Battery
27
Check the battery voltage
•
28
Clean and grease the terminals and check for corrosion and damage
•
29
Check the battery housing for damages
•
Charger
30
Check the main power cable for damages
•
31
Check the start-up protection during charging
•
Function
32
Check the horn function
•
33
Check the air gap of the electromagnetic brake
•
34
Test the emergency braking
•
35
Test the reverse and regenerative braking
•
36
Test the safety (belly) button function
•