Product Manual

17
It is normally off, when it appears (fixed) it shows the request of programmed maintenance or the alarm
state. In this case the relative code will be displayed. The information supplied by the MDI-CAN can be
extremely useful. Failures can be quickly identified by the operator or service technician thereby finding
the fastest solution to the problem.
Hourglass Symbol:
It blinks when the hour meter is working.
c. Charging
• Before charging ensure that you are using an appropriate charger for charging the
installed battery.
• Before using the charger, please fully understand the instructions of the charger
instructions.
• Always follow these instructions.
• The room, where you are charging must be ventilated.
• The exactly charge status can be only checked from the discharge indicator. To
control the status, the charging must be interrupted and the truck must be started.
Park the truck at a dedicated secured area with a
dedicated power supply.
Lower the forks and remove the load;
Switch the truck off and connect the charger plug (19) to
the charging port (20) on the battery. The charger starts
charging the battery if the charger plug (18) is connected
to the main power supply.
Disconnect the charger plug from the battery and close
the cap after the charger finished charging.
When charging is finished, disconnect the plug (18) from
the socket and place it in the designated pocket.
It’s also allowed to remove the battery out and charge in
dedicated area.
Table 3: LED-Status
LED- signal
Function
Red
Charging
Green
Fully charged
Table 4: ChargerPTE33N
Model
Specification
Input
Output
Fig.12: Battery charging