Product Manual

13
Fig. 9: Operating direction
THE MAXIMUM CAPACITY OF BALLYPAL45N IS 4500lbs/2000 kg.
Travel with the lowered forks fully underneath the pallet and press the lifting button (Fig. 7, 15) until you
reached the desired lifting height.
c. Lowering
Press the lowering button (22) carefully.
Lower the load until the forks are clear of the pallet, then
drive the truck carefully out of the load unit.
d. Travelling
TRAVEL ON INCLINES ONLY WITH THE LOAD FACING UPHILL.
DO NOT TRAVEL ON INCLINES MORE THAN SPECIFIED WITH THE TECHNICAL
DATA.
After starting the truck by activation from Pin-code panel, move the tiller to the operating zone (‘F’, Fig.9).
Turn the accelerator button to the desired direction forward ‘Fw.’ or backwards Bw.’(Fig. 9).
Control the travelling speed by moving the accelerator button (Fig.7,13) carefully until you reached the
desired speed. If you move the accelerator button back to the neutral position, the controller decelerates
the truck until the truck stops. If the truck stopped, the parking brake will be engaged.
Drive carefully the truck to the destination. Watch the route conditions and adjust the travelling speed
with the accelerator-button.
Press turtle button (Fig.7,17) to enter into slow speed mode, travel slowly by moving the accelerator
button (Fig.7,13) , press turtle button again to return back to regular mode.
Press turtle button and hold for 2 seconds to realize driving with tiller vertically when in confined area.
e. Steering
You steer the truck by moving the tiller to the left or right side.
Fig. 8: Load facing uphill