Installation Guide

ManualsBrandsUnbranded ManualsLumber & Composites1/8 in. x 24 in. x 6 in. Autumn Mist Real Thin Natural LedgeStone Peel and Stick Panel (5-Pack)

Installation !G u id e!

Please!review!this!installation!guide!before!you!start!or!con tac t!a!pr ofe s siona l!installer.!

NOTE:!

This!stone!is!a!natural!stone!veneer;!therefore,!color!and!texture!variances!are!not!defects!within!the!

material!but!are!inherent!in!any!natural!stone!and!add!to!the!natural!beauty!of!quarried!stone!

Stone!panels!cannot!be!guaranteed!to!match!panel!to!panel!so!it!is!highly!recommended!that!prior!to!

installing!the!panels,!you!open!up!all!of!the!boxes!ordered!for!your!project!and!lay!them!out!to!review!

layout!design,!proper!mixing!of!the!color!shades!and!textures.!!

This!product!is!manufactured!for!dry!interior!applications,!not!for!use!on!shower!walls!or!areas!where!the!

surface!will!be!exposed!to!running!water!

Summary of content (4 pages)

PAGE 1
Installation Guide Please review this installation guide before you start or contact a professional installer.
PAGE 2
Installations Methods Tools and supplies needed: • • • • • • • • • • • Protective eye glasses Caulking gun and adhesive (if using method 2) Measuring scale Straightedge or Speed Square® Soft cloth Pencil Straight Edge Tin Snips for cutting Wood Chisel (with hammer) File Chalk line Level (2’ to 4’) If cutting tiles with a power saw: • • • • Protective eyeglasses Dust mask Safety hand gloves Wet tile saw or chop saw Let’s start Installing NSC’s Real Thin stone panels are a simple, exciting project that a
PAGE 3
high spots, ridges, or uneven areas. Place a level against the wall. If there is a 1/8” gap or greater, use a filler such as spackling or drywall compound to fill in imperfections. Method 2: An additional adhesive should be used, if you do not intend to prepare, sand and prime the surface. We recommend a high-quality polyurethane construction adhesive be applied to the back of each panel in these cases. Be sure to remove the release film on the back of each panel before applying additional adhesive.
PAGE 4
Cutting panels If cutting panels is necessary, use one of our recommended tools and methods listed above. A snip is the recommended cutting method. Alternative cutting methods include a wet saw or chop saw for any necessary straight cuts. Adhering small pieces Use tube adhesive for small cut pieces of Real Thin Stone panels that are less than a third of a full panel. Removing tiles If a Real Thin Stone panel needs to be removed, apply heat with a hair dryer to soften the adhesive.