Users Manual
LED Corn Light Instruction
Application:
LED Retrofit Kit make it simple to replace: parking lot lighting, shoebox lighting,
street lighting, flood lighitng, wall pack lighting, and canopy lighting etc.
Product features:
ƹ
120/280 degree lighting.
Can be with Clear or frosted PC cover.
ƹ
No fan.ƹ
ƹ75-110W lamp can be with AC120-277V internal driver.
75-110W Sealant pouring for whole driver and lamp plastic housing.
ƹ
Long lifespan and good heat dissipation.
ƹ
Direct replacement for Metal Halide, easy Installation.
ƹ
Fits many different fixtures to replace traditional lamps.
ƹ
Installation Instructions:
Warning: Please make sure the power is off before installation.
1. Turn off the power switch.
2. Screw off the CFL or MHL or HPS and so on, see Figure 3 4
3.Take out the led corn lamp and screw it on, make sure the side with the sensor hole is in the same direction as the luminous surface of the lamp,
and then unfold the radiator to 180 degrees, see Figure (1)(2).
Figure 1 ,Figure 2 Regular lamp Lamp with motion sensor or PIR sensor, See the lower right corner for installation instructions.
1 2 :AC internal driver,(Note: Pls make sure to take
off the ballast before installing led corn light,otherwise the ballast will produce
the resonance of high voltage and makes led corn light breakdown.)
4.security rope provided, pls fix the rope on the lamp with hand,
then fix the wire of other end on the shell, see Figure 2 .
5. Turn on the power switch.( Finished!)
Installation of or PIR sensor
motion sensor
It could be easily installed using a straight screwdriver .
Use a flat-blade screwdriver to unscrew the plug and remove
the plug. And then, choose motion sensor or PIR sensor
to install and tighten.
the motion sensor has no dialing code, Note:
and a remote control is needed for adjustment.
Please refer to the instruction for remote
control adjustment.
Figure(3)
Figure(4)
Figure(1) Figure(2)