Use and Care Manual

8
© 2021 United States Stove Company
GETTING STARTED
CAUTION:
GLOVES ARE RECOMMENDED WHEN
HANDLING CERAMIC FIBER LOGS TO PREVENT
SKIN IRRITATION FROM LOOSE FIBERS. LOGS
ARE FRAGILE — HANDLE WITH CARE.
MAKE SURE YOU HAVE RECEIVED ALL
PARTS
Check your packing list to verify that all listed parts
have been received. You should have the following:
• Cast Iron Stove with Burner Assembly
• Installation/Operating Instructions
• Ceramic Fiber Logs
Carefully inspect the contents for shipping damage.
If any parts are missing or damaged, immediately
inform the dealer from whom you purchased the
appliance. Do not attempt to install any part of
the appliance unless you have all parts in good
condition.
WHAT THE GAS TECHNICIAN WILL
NEED FOR INSTALLATION
You must have the following items available before
proceeding with installation:
• External regulator (for Propane/LPG) or high
pressure natural gas (1 to 2 psi system)
• Piping which complies with local codes
• Sediment trap (recommended)
• Pipe wrench
• Pipe sealant approved for use with propane/LPG
(resistant to sulfur compounds)
• Manual shutoff valve
• Tee joint
• Screwdrivers
WARNING:
DO NOT INSTALL THE HEATER …
• WHERE CURTAINS, FURNITURE, CLOTHING,
OR OTHER FLAMMABLE OBJECTS ARE LESS
THAN 42” FROM THE HEATER.
• IN HIGH TRAFFIC AREAS.
• IN WINDY OR DRAFTY AREAS.
WARNING:
IF THE AREA IN WHICH THE HEATER MAY BE
OPERATED DOES NOT MEET THE REQUIRED
VOLUME FOR INDOOR COMBUSTION AIR,
COMBUSTION AND VENTILATION AIR SHALL
BE PROVIDED BY ONE OF THE METHODS
DESCRIBED IN THE NATIONAL FUEL GAS CODE,
ANSI Z223.1/NFPA 54, THE INTERNATIONAL
FUEL GAS CODE OR APPLICABLE LOCAL
CODES.