Installation Guide

ManualsBrandsUnbranded ManualsFireplaces23,500 BTU Vented Dual Fuel Cast Iron Gas Stove Heater

ELECTRICAL INSTALLATION

FEMALE

END

(OPTIONAL)

VARIABLE

SPEED FANS

GND

BATTERY

PACK

885 PROFLAME

MAIN ON/OFF

SWITCH

PILOT

BURNER

FLAME

SENSOR

IGNITER

SW1 BUTTON (RED)

GND

N L

ELECTRICAL SPECIFICATIONS

This appliance, when installed, must be electrically

grounded in accordance with local codes, or in the

absence of local codes, with the National Electrical

Code, ANSI/NFPA 70, or the Canadian Electrical

Code, CSA C22.1.

WIRING REQUIREMENTS

The Ignition Module requires 120V of electricity and/

or batteries to operate.

Using the battery back-up will operate the burner

only.

Optional fan component will not function on

battery back up power.

WARNING:

DO NOT USE THIS UNIT IF ANY PART HAS

BEEN UNDER WATER. IMMEDIATELY CALL A

QUALIFIED SERVICE TECHNICIAN TO INSPECT

THIS APPLIANCE AND TO REPLACE ANY PART

OF THE CONTROL SYSTEM AND ANY GAS

CONTROL WHICH HAS BEEN UNDER WATER.

WARNING:

ELECTRICAL GROUNDING INSTRUCTIONS:

THIS APPLIANCE IS EQUIPPED WITH A

   

YOUR PROTECTION AGAINST SHOCK HAZARD

AND SHOULD BE PLUGGED DIRECTLY INTO

A PROPERLY GROUNDED THREE-PRONG

RECEPTACLE. DO NOT CUT OR REMOVE THE

GROUNDING PRONG FROM THIS PLUG.

WARNING:

ELECTRICAL CONNECTIONS SHOULD ONLY

BE PERFORMED BY A QUALIFIED, LICENSED

ELECTRICIAN. MAIN POWER MUST BE OFF

WHEN CONNECTING TO MAIN ELECTRICAL

POWER SUPPLY OR PERFORMING SERVICE.

ALL WIRING SHALL BE IN COMPLIANCE WITH

ALL LOCAL, CITY AND STATE CODES. THE

APPLIANCE, WHEN INSTALLED, MUST BE

ELECTRICALLY GROUNDED IN ACCORDANCE

WITH LOCAL CODES OR IN THE ABSENCE

OF LOCAL CODES, WITH THE NATIONAL

    



CSA C22.1.