User Manual

For standard (non-PPM) receivers, connect all three wires (ground, 5V, and signal) from
1
Channel 1 from your receiver onto the top left three pins (ground on the left, 5V, then
signal on right). Yes, ground is the brown wire. Channels 2-8 only need the signal wires
from the receiver.!
!
For PPM receivers use the top left three pins on the board only. For PPM receivers, you
will also need to type "feature ppm" in the CLI tab, then type "save", then exit the CLI tab.!
9. Connect a buzzer to the buzzer pins on the board !
You'll need this to hear the beeps for various settings, and to use as a lost model alarm.
You may have one from an old KK board like I did.!
10. Calibrate Accelerometer!
Make sure your quad is level and click on the calibrate accelerometer button.!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
11. Calibrate ESCs!
See my short video.!
!
5
EDITION 4
ACRO NAZE32 GUIDE - DLEARNT
CPPM or PPM=1 cable for 'all' channels (total=8 channels with Acro Naze32); PWM=1 cable for 'each'
1
channel (total=8 channels with Acro Naze32).