Installation Guide

To Adjust Angle of Hand Shower

Rotate holder in vertical direction to set desired hand

shower angle.

To Save Water while Lathering or Shampooing

To save water, turn dial lever to pause mode. For your

safety (to prevent pressure buildup), pause mode has

water dripping instead of complete shut-off. After use, do

not leave dial set to pause mode.

Instruction Manual

To begin your shower experience we want to give you all of

the proper tools to make installation easy and quick. This

way you are that much closer to enjoying an invigorating

shower with your new shower head.

●Remove old shower head and remove all pipe tape as well.

●Insure that the washer from the old shower is not

connected to the pipe. Use a thin utensil to check inside the

pipe for washers, such as a pencil or screw driver. Do not

use your fingers.

●Gather the tools to install the shower head.

Adjustable Wrench (not included)

WARNINGS:

●To avoid hot water dangers and conserve even more energy, make sure your water heater is

set at 120°F (48.9°C) or below.

●Test the shower water with your hand before bathing.

●As with all combination showers,using both shower together always cause water pressure to

drop in each shower head.Use shower head or hand shower individually to maximize water

pressure for high-power performance. Use combined dual-shower application for gentle

pampering, wide flow coverage and targeting of different body areas.

●Always ensure the hand-held shower head is properly placed in the bracket, so as to prevent

the shower head from falling.

●Do not pull on or tug the flexible hose. This may result in the shower head coming loose and

falling.

Manual Manual