Instructions / Assembly

Adjusting the Display

Step 5

Using Cable Management

Step 4

The AEON-40200 / AEON-40300 includes cable

management system where cable can be routed

along the length of the arm assembly.

Route the cable along the entrance of

the cable management slot.(Fig.6)

For optimal performance, route the AC power

cable separately form the signal cables.

With all cables in place, pull the display in and out to

be certain that the arm assembly moves freely, without

stretching or damaging the cables.

NOTE:

U-Cap Cable management

Cable

Fig.6

The AEON-40200 / AEON-40300 provides a wide range of adjustment possibilities

to suit your application . Roll Control - Horizontal leveling of the flat panel display.

Grasp the edge of the display and roll it up or down into a level position (Fig.7).

Tilt Adjustment- Raising or lowering the screen to improve viewing angle.

Grasp the upper and lower edges of the display, and then turn it to the desired tilt angle(Fig.8).

Fig.8

Fig.9

To lock the tilt angle, tighten the tilt knob (Fig.9) securely.

Fig.7

NOTE: For heavier displays, never fully release the tilt knob without fully

supporting the display.

The tilt lever includes a ratchet function, so that it can be lifted and

repositioned for the next turn. To operate the ratchet, pull the lever

straight out, rotate it to an unobstructed position, release the lever,

and then turn it in the desired direction. Repeat as necessary until

the tilt tension is set properly (Fig.10)

Tilt Knob

Fig.10