Instructions / Assembly

M5x16mm (x4 each)-A

M6x16mm (x4 each)-B

M8x35mm (x4 each)-E

Slider Plate(x4)

Mount Arm Assy(x1)

Please do not begin installation until you have thoroughly read and understood these instructions.

Improper installation may cause serious injury and/or damage. It is recommended that a qualified

Make sure that the wall you plan to use will safely support four times the combined weight of the

mounted equipment, including its accessories.

The supports LCD, LED and Plasma Flat Panel

Displays

This products suits displays with

mounting hole patterns from 200x200mm (8"x8") to 600x400mm (24"x16").

The manufacturer does not accept responsibility for incorrect installation.

A second person will be required to assist with several steps.

Adaptor Plate Body(x1)

Lag Bolt

8*70mm(x4)

Anchor(x4)

Spacer (x4)

5mm Allen Key (x1)

WARNING

Tools Needed for Assembly

• Stud finder ("edge to edge" stud finder is recommended)

• Phillips screwdriver

• Pencil

• Hammer Drill(Concrete installation only), otherwise a standard drill

• 1/4" drill bit for wood studs, 1/2" drill bit for concrete

• 1/2" socket wrench or bit driver for wood screws

• Level

• Tape measure

Adaptor Brackets(x2)

Metal washer (x88Ø )

Socket pan head screw

M8*12mm (x4)

Metal washer (x86Ø )

Philips head screw

M6*15mm (x4)

contractor install the AEON-40200 / AEON-40300 Universal Cantilever Mount.

AEON-40200/ AEON-40300 Full Motion Mount

from 32

to 60" and supports a maximum load of ( )125 lbs .

M/N

Warranty will be void if TV Mount is not installed

to wood studs or masonry.

M8x9mm (x4 each)-D

PLEASE NOTE: IMPROPER INSTALLATION WILL VOID WARRANTY.