Features Applicable to all scale model planes Can control landing gear and two gear doors through one channel Can set up the delay time between each step Can set up the three servos’ start and end position Big size numerical code tube as setting interface V.3.0 is more easy setting and safer running.
HOW TO USE Warning: If it is your first time using this controller, you need read the entire manual carefully before use. SETTING At first, connect the servos without load, connect the JR connector to the receive channel that you have decided on. Then power on, the display will show F1 at first, which means the controller is in mode F1. If you want to change to mode F2 or F3, press FUNC- and FUNC+ both for more than 2 seconds to change. About the meaning of F1, F2, F3, please see Note Table 1.
L1 L2 L3 L4 Door 2 L5 Gear Door 1 TOP VIEW A B C D FUNC + FUNC - VOL + VOL - To CH on Receiver L1 to L5 is five numerical code tubes. L1 show function code, L2 to L5 show value. The details are listed in the tables below. FUNC+, FUNC-, VOL+, VOL- are Buttons, these are used to change the mode, to start and to set, etc. Door1, Gear and Door2 are the connectors to operate servos. The JR connector is used to connect to your control channel on the receiver.
Note Table 1: Working Mode F1 Radio control channel switch ON Radio control channel switch OFF Working Mode F2 Radio control channel switch ON Radio control channel switch OFF Working Mode F3 Radio control channel switch ON Radio control channel switch OFF Door 1,2 Open first Waiting (Delay 1) time Landing Gear Down Landing Gear Up first Waiting (Delay 2) time Door 1,2 Close Door 1,2 Open first Waiting (Delay 1) time Landing Gear Down Waiting (Delay 2) time Door 1,2 Close Door 1,2 Open first Waitin
7 8 9 a b c d +/- 150 +/- 150 1 ~ 999 +/- 150 1 ~ 999 +/- 150 +/- 150 Door 1 opened position, +/-150% Door 2 opened position, +/-150% Delay 3, XXX* 0.1 Second Landing Gear Up Position, +/-150% Delay 4, XXX* 0.1 Second Door 1 closed position, +/-150% Door 2 closed position, +/-150% Factory Default = 100% Factory Default = 100% Factory Default = 10*0.1 sec Factory Default = 100% Factory Default = 10*0.
