Use and Care Manual

10
In case of the W ATER F ULL (P2) LED alert, the unit is required
to be drained. At the end of AC Season, this unit should be
drained p r ior to storage. In both situations, we recommend
that you take t he following s t ep s .
Switch off the unit and remove the plug from the outlet.
• Position a flat container or dish on the floor under
the drain hole. Use container only for temporary
draining of the unit, do not allow the water to drip
continuously into the container, as it might easily
over flow.
• Remove the drain knob.
• Remove the rubber plug, the water will flow in the
container. When this is nearly full, replace the plug
to stop the water flow and empty it. Repeat this
process until all water has been removed.
Rubber Plug Drain Knob
• For seasonal storage purposes, put the unit ON in fan mode on a warm, dry day for
a couple of hours to ensure that the inside can dry out completely. We also recom-
mend allowing the unit to air dry for a period of 24 hours without the drain plug and
cap in place.
• Insert the rubber plug into the drain hole firmly,
the WATER FULL LED (P2) should not flash any longer.
• Screw on the drain knob.
Additional maintenance/tasks prior to s t o r a g e .
• Clean the filters.
• Store the power cable as shown, protect the unit against dust (put back into its
original carton) and store in a dry place not accessible for children.
• To protect the unit against dust, store in a dry place not accessible by children
• Do not stack heavy objects on top of the unit
Emptying the Water Container