Use and Care Manual

9
Op e r a t i o n
Cooling Mode
· After machine turns on, default value is cooling mode with 72ºF and low fan speed.
· Press “MODE” to select cooling mode, cooling mode indictor turns on.
· Press “UP” or “DOWN” to adjust temperature (from 60ºF to 90ºF).
· Press “FAN” to select fan speed (low, high)
Heating Mode
· Press “MODE” to select heating mode, heating mode indicator turns on (only for cooling and heating model).
· Press “UP” or “DOWN” to adjust temperature (from 60ºF to 90ºF).
· Press “FAN” to select fan speed (low, high)
Fan Mode
· Press “MODE” to select fan mode, fan mode indicator turns on .
· Press “FAN” to select fan speed (low, high)
· Temperature and sleeping function cannot be setup.
Timer Mode
· Under standby mode, press “TIMER” to setup the power-on time,
press “UP” and “DOWN” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.
· Under power-on mode, press “TIMER” to setup power-off timer.
Press “UP” and “DOWN” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.
Sleeping Mode
· Press key “SLEEP” enters into sleeping mode, default value of fan speed is low.
· When sleeping mode turns on, under cooling mode, the one hour later, setting temperature will go up
1º, the second one hour later, setting temperature will go up another 1º, and then keep the same; under heating
mode, the first one hour later, setting temperature will go down 1º, the second one hour later, the setting
temperature will go down another 1º and then keep the same .
· Sleeping mode is invalid under dehumidifying and fan mode.
Under water full, machine standby and mode conversion, sleeping mode will be cancelled.
Compressor Protection
· Three minutes later after power on / restart, compressor starts to run.