Installation Guide

e Vintage Wood Floor Company VintageWoodFloors.com
e Antique Barrel Collection AntiqueBarrelCollection.com
714-557-9655
[e-mail]
diy stacked
wall panels
Installation Guide
If you have questions during installation or about your purchase please call 949-244-5123. DO NOT return to retailer.
Keep in mind, the panels
are created with offset
ends/joints. Because of
this, you will never be able
to tell where one panel
ends and another begins.
Using a chop saw, make
a cut across the panel to
create a straight edge to
start.
Hold the rst panel in
place at the bottom left of
the rst row to be secured.
Using your brad nail gun,
secure the plank in place,
making sure to hit the
studs where possible.
If you are unsure of stud
placement, drive the nails
at a downward angle.
Secure successive panels
in the same row to your
right as you did with the
rst panel.
When you reach the end
of the rst (or any row),
measure and cut off
excess. We suggest that
you begin the next row
above with the cut-off
from the previous row.
Begin the next row above
the row you just completed
with the previous row’s
cut-off.
Otherwise, take your
next panel and secure it
in place as you did the
previous row.
When you get to the top and nal row you
may nd that you need to trim the overall
height of the panel. This is the case if the
height of the wall/surface doesn’t equally
divide by the height of each panel.
Trim these nal planks with a table saw for
the straightest cut possible. If you do not
have a table saw, a hand-held circular or
jig-saw will be ne.
And, that’s it! You’re done!