Installation Guide

ManualsBrandsUnbranded ManualsBuilding materialsAress B52 Anodized 8 ft. Aluminum Handrail Stair Kit

B52 - HANDRAIL INSTALATION GUIDE

Aress Corp

6925 Lake Ellenor Dr. Bldg. 5 Ste. 502, Orlando, Fl 32809 USA

407-270-4982

1. TOOLS CHECK 2. WHAT LENGHT DO YOU NEED?

•

Pencil

•

Two pieces of paper

•

Tape

•

Tape measure

•

Simple drilling machine or Rotary Hammer if ﬁxing your rail on

concrete

Handrail

•

Aress Corp recommands to install a handrail

whose length matches the length between the ﬁrst

and the last steps of your stairs

Summary of content (6 pages)

PAGE 1
B52 - HANDRAIL INSTALATION GUIDE 1. TOOLS CHECK 2. WHAT LENGHT DO YOU NEED? Handrail • • • • • Pencil Two pieces of paper Tape Tape measure Simple drilling machine or Rotary Hammer if fixing your rail on concrete • Aress Corp recommands to install a handrail whose length matches the length between the first and the last steps of your stairs Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.
PAGE 2
3. PAPER SHEETS 34’’ 4. LINE DRAWING 34’’ Pipe 34’’ • • Tape the two paper sheets on the wall, aligned with the first and the last steps as shown on the picture. Measure 34’’ height from the steps and put a pencil mark on the papers • Align your pipe with your two pencil marks and draw a line between them (only on the papers, not on your wall) Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.
PAGE 3
5. HOLES DRAWING 6. HOLES DRAWING Wall mount 4’’ • • • • Align your wall mount holes with you line and place it 4’’ away from the exterior side of the paper sheets (4’’ from the left side of the paper for the bottom paper and 4’’ from the right side for the upper paper as shown in picture) Draw circle inside your wall mount holes with your pencil Repeat the process on the other paper sheet You know have your drilling marks on both paper sheets Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.
PAGE 4
7. WALL MOUNT DRILLING • 8. WALL MOUNT SCREWING • Drill using the adapted drilling machine depending on you wall’s material. Screw both of the mounts using adapted screw depending on your walls (screws not included as they depend on your wall’s material) Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.
PAGE 5
9. PIPE FIXING 10. PIPE SCREWING X’’ X’’ • Adjust your pipe in order for it to be centered regarding the two wall mounts • Screw the pipe onto the wall mounts using the included screws Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.
PAGE 6
9. ADDITIONAL WALL MOUNT • • 10. ENJOY For the 5’, 6’ and 7’, you will have to fix a third wall mount in the middle of the pipe For the 8’ and 9’ you will have to fix two other wall mounts apportioned between the extremity ones. • Dont forget to put the end-cups at both pipe’s extremities. Aress Corp 6925 Lake Ellenor Dr. Bldg. 5 Ste.