Installation Guide

18
Operation
COLOR
COLOR button: Makes the color flame
effect changing.
NOTE: color effect stays on until power
button is turned off. Color flame effect
must be on for heater to turn on.
NOTE: this fireplace is with memory
function for flame.
1. Press once. Flame color effect gets
changing.
2. Press again until desired setting is
reached.
HEATER
HEATER button: Turns heater on andoff.
NOTE: The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE: Heater button can be locked or
unlocked by holding the Heater button for
5 seconds.
1. Press once. Indicator lightsup.
Fan blows cool air for 10 seconds.750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
TEMP
TEMPERATURE button: Turns heater
on and off.
NOTE: Press & Hold the button for 5 seconds,
the temperature setting will switch from ℃ to
℉. Same way from ℉ to ℃。
1. Press once: Indicator lights
up. Temperature goes to 18
℃
2. Press again: until desired setting
is Reached. Digital display shows
setting circles asbelow:
LED Bottom light button ( 1 ): Makes
the color on bottom effect changing.
NOTE: Ember color effect stays on until
power button is turned off.
1. Press once. Ember color effect
gets changing.
2. Press again. until desired setting is
reached, in total 10 colors recycling.
LED Bottom light button ( 2 ): Makes
the color on bottom gets flash changing
automatically.
NOTE: Ember color effect stays on until
power button is turned off.
1. Press once. Ember color effect
gets flash changing automatically.
2. Press again to turn off flashing.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT
press the buttons too quickly. Give the unit time to respond to each command.