Installation Guide

17
Operation
Read and understand this entire owner’s manual, including all safety information,
before plugging in or using this product. Failure to do so could result in electric shock,
fire, serious injury, ordeath.
Power
Plug the power cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY
INFORMATION on Pages 3 and 4). Make sure the outlet is in good condition and that the plug is not
loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other appliances into the
same circuit.
Methods of Operation
This electric fireplace can be operated by the TOUCH-ON CONTROL PANEL, located on the front
right side glass panel, or by the battery-powered REMOTE CONTROL.
Remote Control
Touch-on Control Panel
Touch Panel / Remote Control Operation
BUTTON
FUNCTION
ACTION & INDICATION
POWER
ON: Enables control panel functions
and remote control. Turns on flame
effect.
OFF: Disables control panel functions
and remote control. Turns off flame
effect.
1.Press once. Indicator light turns
on. Power turns on. All functions
enabled.
2.Press again. Flame effect turns off.
Unit goes to standby. All functions turn
off.
TIMER
TIMER button: Controls timer
settings to turn off fireplace at
selectedtime.
Settings range from 0.5 hours to 8
hours.
1. Press once. Indicator light
turns on. Timer is set to 0.5 hours.
2.Press again until desired
setting is reached. Indicator lights
show setting.
FLAME
FLAME button: Makes flame
effect dimmer and brighter.
NOTE: Flame effect stays on until
power button is turned off. Flame
effect must be on for heater to turn
on.
1.Press once. Flame brightness
effect gets changing.
2.Press again. until desired
setting is reached.