Installation Guide

11
Fig.
5-1
Fig.
5-1
Fireplace Installation
There are 3 OPTIONS TO INSTALL THE FIREPLACE:
i. SURFACE WALL MOUNT INSTALLATION
Due to the many different materials used on different walls, it is highly recommended
that you consult your local builder before you install this appliance on the wall.
A. Select a location that is not prone to moisture and is located at least
36" (91.4cm) away from combustible materials such as curtain
drapes,furniture, bedding, paper, etc.
B. Remove the front glass (see “front glass removal / installation” section).
C. Have two people hold the appliance against the wall to determine
the final location.
D. Place appliance face down on a soft, non abrasive surface. Remove
the bracket from the back of the appliance by removing the screws
(Fig.5-1). Set the bracket aside and discard the screws.
E. Mark out location, then mount the bracket onto the wall using screws
(supplied). This bracket MUST have
the hooks facing upward and be
level
(Fig. 5-2).
A x 6 for BG-50/60B
B x 6 for BG-50/60B
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If
the wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to
the wall and the bracket is adequately secured.
A x 8 for BG-72B
B x 8 for BG-72B