Instructions / Assembly

Table Of Contents

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Remove the canopy ring (K) from the canopy (C) by turning

the ring to the right until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the four screws on the top of the canopy (C).

□ Remove the two non-slotted screws, and loosen the slotted

screws. This will enable you to remove the mounting bracket

(A).

□ Route the wires exiting the top of the fan motor (D) into

the decorative motor collar cover (F) and through the

canopy ring (K).

□ Make sure the slot openings are on top and route the

wires through the canopy (C) and then through the ball/

downrod assembly (B).

□ Remove the setscrew (DD) by turning it counterclockwise.

□ Install the downrod (B) by inserting it into the motor collar (M),

and turning it clockwise until it is tight.

□ Reinstall the setscrew (DD) turning clockwise until tight.

NOTE: This fan is equipped with a safety tab (EE). Should

the setscrew (DD) ever become loose while the fan is

running in reverse, the safety tab (EE) will engage and

stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(DD) must be completely tightened