91041 1,800 LB. MOTORCYCLE STAND / WHEEL CHOCK CUSTOMER SERVICE: Any help needed, please call 877-713-3189 (Toll Free), or email: Support@fot-usa.
IMPORTANT SAFETY INFORMATION Definition of Symbols This is a SAFETY ALERT symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING concerning Risk of Eye Injury. Wear ANSI approved eye protection. WARNING concerning Risk of Hearing Loss. Wear hearing protection. DANGER DANGER indicates a hazardous situation which, if not avoided, will result in death or injury.
Personal and Work Area Safety (continued) F. While setting up and using the Motorcycle Wheel Chock keep work area clean and well lighted. Keep spectators and children out of the work area. 3. Use of the Motorcycle Wheel Chock A. This Wheel Chock is designed to fit most motorcycles. There are some extra wide tires and specially designed front fenders which will not fit in the Wheel Chock. Do not exceed the Wheel Chock’s tire size capacity and do not modify the design of the Wheel Chock. B.
Assembling and Mounting the Motorcycle Wheel Chock and Stand 1. Refer to photo above and to the Assembly Drawing at end of this manual. 2. Once assembled, this Motorcycle Wheel Chock must be mounted to a solid, level concrete surface, or in the bed of a truck. 3. To assemble the Wheel Chock: Always wear ANSI approved safety goggles. A. Assemble Front Support (4) to the front, closed end of the Stand Base (3), using Bolts (12), Washers (7) and Nuts (8).
require appropriate ramps (not included). The motorcycle must also be secured to the truck bed with straps or belts (not included). SPECIFICATIONS Material Composition Formed Steel with Carbon Steel Hardware Adjustable to 6 positions for different wheel sizes 1,800 Lbs. 15” to 22” Diameter 3” to 5” Wide To load the motorcycle into the Wheel Chock, lower the leading edge of the Wheel Bracket (2) and slowly push the motorcycle into the Stand. It is recommended that an assistant help with this task.
Parts List Part # Description 1 2 3 4 5 6 7 8 9 10 11 12 Qty Wheel Cradle Wheel Bracket Stand Base Front Support Eyelet Leg Plug Washer, size 10 Nut, M10 Washer, size 12 R-Pin Rod Bolt, M10 x 45 1 1 1 1 2 2 2 2 4 4 2 2 Assembly Drawing 1 4 2 8 7 5 12 6 3 11 10 12 Note: The Parts List and Assembly Diagram is provided as a reference tool only. Some parts are listed and shown for illustration purposes only, and are not available as replacement parts.
