User manual

Quartz long pendulum movement
Version 05/11
Item no. 67 24 35
Intended use1.
The product is intended for working with clock arms (not included) to provide time information and it also comes with
a ornamental pendulum. The product is powered by one AA battery (not included). It is only authorised to be used
in dry indoor environment.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
causehazardssuchasshortcircuiting,re,electricshocketc.Readtheinstructionscarefullyandkeepthem.
Make this product available to third parties only together with its operating instructions.
Delivery content 2.
Quartz pendulum movement•
Pendulum rod•
Pendulum lens•
Battery cover•
Hanger•
Washers •
(1 x big rubber washer, 3 mm / 1 x small washer)
Centralxingnet(17mm)•
Hand nut•
Operating instructions•
Safety instructions3.
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
Persons / Product
The device is not a toy. Keep it out of the reach of children and pets.•
Do not leave packaging material lying around carelessly. These may become dangerous playing material •
for children.
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, •
ammablegases,vapoursandsolvents.
Do not place the product under any mechanical stress.•
If it is no longer possible to operate the product safely, take it out of operation and protect it from any •
accidental use. Safe operation can no longer be guaranteed if the product:
is visibly damaged, -
is no longer working properly, -
has been stored for extended periods in poor ambient conditions or -
has been subjected to any serious transport-related stresses. -
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the •
product.
Battery
Correct polarity must be observed while inserting the battery.•
The battery should be removed from the device if it is not used for a long period of time to avoid damage •
through leaking. Leaking or damaged batteries might cause acid burns when in contact with skin, therefore
use suitable protective gloves to handle corrupted batteries.
Batteries must be kept out of reach of children. Do not leave the battery lying around, as there is risk, that •
children or pets swallow it.
Batteries must not be dismantled, short-circuited or thrown into re. Never recharge non-rechargeable•
batteries.Thereisariskofexplosion!
Miscellaneous
Consult an expert when in doubt about operation, safety or connection of the device.•
Maintenance,modicationsandrepairsaretobeperformedexclusivelybyanexpertorataqualiedshop.•
If you have questions which remain unanswered by these operating instructions, contact our technical•
support service or other technical personnel.
Assembly4.
9
10
8
7
6
5
4
3
2
1
Assemble the parts in the following the order:
Quartz pendulum movement1.
Big rubber washer2.
Dial and base of the case (not included)3.
Small washer4.
Centralxingnut5.
Hour hand (not included)6.
Minute hand (not included)7.
Hand nut8.
Second hand (not included)9.
Cover of the case (not included)10.
Completion
Insert the hanger according to your needs.1.
Insert the pendulum rod into the pendulum lens while observing the correct orientation. The hook of the rod 2.
should face towards the bottom of the lens.
Hang the pendulum rod on the pendulum movement while observing the correct orientation. The hook 3.
should face towards the back of the pendulum movement.
Battery insertion / replacement5.
Slide out the battery compartment cover at the back of the pendulum movement.1.
Insert an AA battery while observing the correct polarity.2.
Close the battery compartment.3.
Operation6.
Set the time with the green turning knob at the back of the pendulum movement.1.
Hang the pendulum at your desired location in an upright position.2.
When the clock stops running or time deviation is observed, replace the battery.3.
The clock’s operation is not based on the pendulum movement. The clock can operate without
having the pendulum attached.
Disposal7.
General
Inordertopreserve,protectandimprovethequalityofenvironment,protecthumanhealthand
utilise natural resources prudently and rationally, the user should return unserviceable product to
relevant facilities in accordance with statutory regulations.
The crossed-out wheeled bin indicates the product needs to be disposed separately and not as
municipal waste.
Batteries / rechargeable batteries
The user is legally obliged (battery regulation) to return used batteries and rechargeable batteries.
Disposing used batteries in the household waste is prohibited! Batteries/ rechargeable
batteries containing hazardous substances are marked with the crossed-out wheeled bin. The
symbol indicates that the product is forbidden to be disposed via the domestic refuse. The
chemical symbols for the respective hazardous substances are Cd = Cadmium, Hg = Mercury,
Pb = Lead.
You can return used batteries/ rechargeable batteries free of charge to any collecting point of your
local authority, our stores or where batteries/ rechargeable batteries are sold.
Consequentlyyoucomplywithyourlegalobligationsandcontributetoenvironmentalprotection!
Technical data8.
Operating voltage: 1.5 V/DC, 1 x AA battery (not included)
Pendulum length: 400 mm
Dimensions (W x H x D): 73 x 57 x 41 mm (movement only)
Weight: 48 g (movement only)
Hands – requirements:
Hands Second Minute Hour
Recommended length: max. 120 mm - -
Recommended weight: max. 0.8 g max. 0.8 g max. 0.8 g
Typicaltorque: 3 g/mm min. 100 g/mm min. 200 g/mm
Bushing thickness: 0.8 (+0/ -0.01) mm 3.5 (+0/ -0.02) mm 5 (+0/ -0.03) mm
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
All rights including translation reserved. Reproduction by any method, e.g.
photocopy,microlming,orthecaptureinelectronicdataprocessingsystems
requirethepriorwrittenapprovalbytheeditor.Reprinting,alsoinpart,isprohibited.
Theoperatinginstructionsreectthecurrenttechnicalspecicationsattimeofprint.
Wereservetherighttochangethetechnicalorphysicalspecications.
© 2011 by Conrad Electronic SE.
V2_0511_02-HL